Col-Met Spray Booths, Inc. is a manufacturer of quality automotive paint booths and industrial type finishing enclosures.

Col-Met specializes in spray booths for paint and powder applications, batch ovens and oven panels.

A few standard products are displayed here. If special engineering is required, we welcome the opportunity to design and manufacture products for your specific needs.

The COL-MET Classic Crossdraft Booth intakes fresh air through filters in the product doors. The clean filtered air is drawn through the booth and exhausted through a filter system at the other end. This type of spray booth makes efficient use of shop space and is available in solid back, drive-through and reverse flow designs. Reverse flow booths intake air through filters in the back wall. The solid faced product access doors are at the exhaust end of the booth. This provides cleaner intake filtering and better control of shop dust that might be tracked in at the vehicle entrance.

Bright full booth illumination is provided by ten, four tube, 48"-32 watt fluorescent light fixtures in the angled ceiling panels and side walls. Each is sealed behind clear tempered safety glass. All fixtures are UL listed and approved for their intended use and placement. The light tubes are not furnished with the fixtures.

The Full Downdraft Booth is a very efficient design, intaking fresh air from the cleaner upper levels of the shop, through filter banks in the ceiling. The clean filtered air is then drawn down and around the product, through a filtered exhaust system pit in the floor underneath. This design tends to keep over spray away from unpreped product areas, and also away from the painter and other painters in the booth. The booth is equipped with an air supply plenum and is available in both solid back and drive-through designs.

All Truck Trailer and Equipment booths can be equipped with air replacement units that control inside air pressure, temperature and cure cycles to meet your requirements.

Bright full booth illumination is provided by four tube, 48"-40 watt fluorescent light fixtures in the angled ceiling panels and side walls. Each is mounted behind clear tempered safety glass and sealed with a trimlock gasket. All fixtures are UL listed and approved for their intended use and placement. The light tubes are not furnished with the fixtures.

All booth and plenum sections are made with 18 gauge galvanized steel. All product and personnel access doors are double skinned for ease of maintenance, and treated for noise control. Panic latches and limit switches are provided for each door opening. All Truck Trailer and Equipment booths are rigidly reinforced with external "I" beams.

All exhaust fan units are equipped with TEFC motors and sized for more than adequate air flow movement to meet all quality code standards. The control panels and other electrical components are to be supplied by others. All hardware, filters and sealants needed for the booth installation are included.